• Insert the SD card into the slot located on the camera board.
• Insert the batteries, making sure to align them according to the positive (+) and negative (−) polarity markings.
• Close the camera case panel securely.
• Tighten the screws to lock the front and back panels in place.
• Assembly complete!

🔋 Important Notes Before Use

• Remove the protective insulation layer from the outside of the batteries before inserting them.
• To ensure optimal performance, please fully charge the NiMH batteries for three hours before initial use.

🔋 Battery depletion is the root cause of most reported issues with Paper Shoot cameras.
Please follow the steps below to determine if the problem is battery-related:

❌Take out the batteries from the camera.
🔌Plug a power bank into the USB-C port on the side of the camera.
↔️Move the mode switch on the back of the camera to the first position on the left (Standard Mode).

✅ If the camera functions normally after these steps, the issue is likely due to low battery power or faulty batteries.